ZANKER ZKF 780 Installations & Bedienungsanleitung Seite 16

Fitting the hob to the worktop
Carry out the building in of the hob as follows:
1. Place the seals supplied with the hob on the
front edge of the cut out. Then, place them at 86
mm from the side edges and at 10 mm from the
rear edge, as shown in the diagram 7, taking
care that the seals meet without overlapping.
2. Place the hob in the cut out, taking care that it is
centred.
3. Fix the hob with the relevant fixing clamps,
supplied with the injectors kit (see diagram 8).
When the fixing brackets have been tightened, the
excess seal can be removed.
The overlaying sealing material should be removed
using a wooden or plastic knife in order to avoid
damaging the worktop.
To completely remove the sealing material please
position the plastic knife at an angle (Position at an
angle of 45°C).
The edge of the hob forms a double seal which
prevents the ingress of liquids.
16
Fig. 7
Seal
Fig.8