Residual Risks; Safety Instructions For Devices; General Safety Instructions; Before Use - Fuxtec Fx-Rm4180 Bedienungsanleitung

Residual risks

Even if you operate this device according to the instructions, there are always residual risks. The
following hazards may occur in connection with the design and construction of this device:
•
Injuries and property damage caused by flying parts.
•
Hearing impairment if you do not wear suitable hearing protection or use the device for an extended period.
•
Damage to health results from hand-arm vibrations if the device is used for a long time or is not guided correctly
and maintained.

14. Safety instructions for devices

General safety instructions

- For your safety and the safety of others, read this instruction manual and its safety instructions
before using the appliance. Please keep the operating instructions and
your safety instructions in a safe place for later use and
keep them handy for every application.
- Pass on the operating instructions with the device if there is a change of ownership.
- Persons operating the device must not be under the influence of intoxicants (e.g., alcohol, drugs, or
medication).
- Only operate the device in the technical condition specified and delivered by the
manufacturer. Unauthorised modifications to the device exclude the manufacturer's liability for any
resulting damage.
- Use the device only in daylight or under good artificial lighting.
- Only use the device in dry weather conditions. Please keep it away from rain or wetness. The
ingress of water into the device increases the risk of electric shock.
- Switch off the device and remove the battery in the following conditions:
⬧ if the device is left unattended;
⬧ if the device starts to vibrate excessively.

Before use

- Before starting work, familiarise yourself with the device and its functions and controls.
- Check the device for signs of wear or damage before commissioning and after an impact.
- Do not use a device whose switch is defective and can no longer be switched on or off.
- Check that all nuts, bolts, and screws are tight to ensure that the device is operated safely.
Manual_FX-RM4180_Int24_Rev3
27