Maintenance; Troubleshooting; Storage; Error Correction - Parkside Pags 20-Li A1 Originalbetriebsanleitung

GB MT
Cleaning and maintaining the blade
Tools and aids required (not in-
cluded)
• Cloth
• Care oil spray
Care after each use
• Remove any green cuttings that
are stuck.
• Clean the grass and shrub shears
blade (14)/(10) with an oily cloth.
• Maintain the grass and shrub
shears blade (14)/(10) with a care
oil spray.

Maintenance

• Check the tool before each use
for obvious defects such as loose,
worn or damaged parts. Ensure
that the screws on the grass and
shrub shears blade (14)/(10) are
firmly in place.
• Check the covers and protective
devices for damage and correct fit.
Replace these if necessary.
• You can smooth out slight nicks on
the cutting edges yourself. To do
this, pull off the cutting edges with
an oil stone. Only sharp blades

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
38
• Blunt, bent or damaged blades

Storage

Always store the device and ac-
cessories:
• clean
• dry
• protected against dust
• out of the reach of children
• with blade guard (15)/(13) over the
The storage temperature for the re-
chargeable battery and the device
is between 0°C and 45°C. Avoid ex-
treme cold or heat during storage to
ensure the battery output is not ad-
versely affected.
Remove the battery from the device
before storing the device (see the
separate operating instructions for
the battery and charger).
Possible cause
Rechargeable battery (5)
not inserted
Rechargeable battery (5)
discharged
Switch lock (1) or On/Off
switch (2) defective
Defective motor
provide a good cutting perform-
ance.
must be replaced (see Spare parts
and accessories, p. 42).
grass and shrub shears blade (14)/
(10)
• The blade guard is an important
safety device. If the blade guard
is damaged, do not use it and
replace it straight away.

Error correction

Inserting the battery,
p. 37
Charge the battery (see
the separate operating
instructions for the re-
chargeable battery and
charger)
Contact the service
centre.