• On/Off switch (2)
• Switching on: Press
• Switching off: Release
Attaching/replacing an
accessory
CAUTION! Switch off the device
and remove the rechargeable bat-
tery before attaching or replacing ac-
cessories in order to avoid hazards
and injury.
Attaching an accessory
Procedure (Fig. A)
1. Place the lug (12) of the grass
shears blade (14) or the shrub
shears blade (10) in the groove on
the underside of the device head
(9).
2. Fold the accessory in the direction
of the device head (9).
3. Press the two blade release but-
tons (11) on the right and left of the
accessory.
4. Let go of the blade release buttons
(11) when the accessory is flush
against the device head (9).
5. Check that the accessory is firmly
seated by pulling on the access-
ory.
Removing an accessory
Procedure (Fig. A)
1. Press the two blade release but-
tons (11) on the right and left of the
accessory.
2. Fold the accessories away to the
front.
3. Remove the accessories by lifting
them upwards.
Checking the battery
charge level
LEDs
red, orange, green Battery charged
red, orange
red
1. Press the button (7) next to the
charge level indicator button (6) on
the battery (5).
The LEDs of the charge level in-
dicator show how much charge re-
mains in the battery.
2. Charge the battery (5) when only
the red LED on the charge level in-
dicator (6) is illuminated.
Charging the battery
See also the charger instruction
manual.
Notes
• If warm, allow the battery to cool
before charging.
• Do not expose the battery to dir-
ect sunlight for long periods and
do not place it on a radiator (max.
50°C).
Charging the battery
1. Remove the battery (5) from the
device.
2. Push the battery (5) into the char-
ging slot of the battery charger
(17).
3. Connect the battery charger (17) to
a power outlet.
4. After charging, disconnect the bat-
tery charger (17) from the mains.
5. Pull the battery (5) out of the bat-
tery charger (17).
GB
MT
Meaning
Battery partially
charged
Battery needs to
be charged
35