Operation; General Working Instructions; Before Operation; Inserting And Removing The Battery - Parkside Pags 20-Li A1 Originalbetriebsanleitung

GB MT
Control LEDs on the charger (17):
green red
lights up —
— lights up Battery is char-
— flashes
flashes flashes

Operation

General working
instructions
WARNING! Risk of injury! Pay at-
tention to the following instructions.
• Always wear sturdy shoes, long
trousers, ear protection, work
gloves and protective goggles
when operating the device.
• The device is only intended for
work where you are standing on
the ground and not on a ladder or
other unstable surface.
• Comply with the device's mainten-
ance and cleaning instructions.
• If the grass and shrub shears blade
(14)/(10) becomes jammed with
solid objects, turn the device off
immediately and remove the bat-
tery. Only then should you remove
the object.
• Only use sharp blades to en-
sure good cutting performance
and to protect the device and re-
chargeable battery.
• You can smooth out slight nicks on
the cutting edges yourself. To do
this, pull off the cutting edges with
an oil stone. Only sharp blades
36
Meaning
• Battery is fully
charged
• stand-by (No
battery inser-
ted)
ging
Battery is over-
heated
Battery is defect-
ive
provide a good cutting perform-
ance.
• Do not overload the device while
working to such an extent that it
comes to a standstill.
• Do not use the device if a switch is
damaged.
Working using the grass shears
• Grass is best cut when it is dry and
not too high.
Working using the shrub shears
(hedge trimmer)
• Move the device in a steady for-
ward motion, or up and down in an
arch-shaped motion.
• The double-sided shrub shears
blade (10) enables trimming in both
directions or via pendulum move-
ments from one side to the other.

Before operation

Carry out the following steps before
each operation. This will guarantee
long and reliable use.
• NOTICE! Damage to the grass and
shrub shears blade (14)/(10). While
cutting, make sure that you do not
touch any objects, such as stones,
wire fences or plant supports.
• Check the tool before each use
for obvious defects such as loose,
worn or damaged parts. Ensure
that the screws in the grass and
shrub shears blade (14)/(10) are
firmly in place.
• Do not cut with a dull or worn
grass and shrub shears blade
(14)/(10), otherwise you will over-
load the motor and gears of your
device.
Inserting and removing the
battery
WARNING! Risk of injury due to
unintentional start-up. Only insert