Maintenance; Storage; Troubleshooting - Parkside Performance Pwsap 20-Li F6 Originalbetriebsanleitung

Cleaning the dust protection grille
(Fig. E)
• Clean the dust protection grille (3)
with a brush.
• You can remove the dust protec-
tion grille for thorough cleaning.
To do this, insert a narrow slotted
screwdriver at the marked point.
Replace a defective dust protec-
tion grille (Spare parts and ac-
cessories, p. 55).

Maintenance

The device is maintenance free.

Storage

Always store the device and ac-
cessories:
• clean
• dry

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Attachment tool does not
move although motor is
running
Engine is slowing down
and stops
Attachment tool does not
rotate smoothly, abnormal
noises can be heard
• protected against dust
• In the case provided (29)
• out of the reach of children
The storage temperature for the re-
chargeable battery and the device is
between 0 °C and 45 °C. Avoid ex-
treme cold or heat during storage to
ensure the battery output is not ad-
versely affected.
Remove the rechargeable battery
from the device before storing the
device (see the separate operating in-
structions for the battery and char-
ger).
Storing cutting/grinding discs
• dry
• upright
• unstacked
Possible cause
Rechargeable battery (22)
not inserted
On/Off button (15) defect-
ive
Defective motor
Clamping nut (26) loose
Workpiece, workpiece
remnants or remnants of
attachment tools blocking
the drive
Device is overloaded
through workpiece
Clamping nut (26) loose
Attachment tool defective Changing the attachment
GB
Error correction
Inserting the battery,
p. 48
Contact the service
centre.
Contact the service
centre.
Tightening the clamping
nut
Remove blockages
Reduce pressure on at-
tachment tool
Workpiece unsuitable
Tightening the clamping
nut
tool
MT
51