Residual Risks - Parkside Performance Pwsap 20-Li F6 Originalbetriebsanleitung

Safety Warnings Specific for Wire
Brushing Operations
• Be aware that wire bristles are
thrown by the brush even during
ordinary operation. Do not over-
stress the wires by applying ex-
cessive load to the brush. The
wire bristles can easily penetrate
light clothing and/or skin.
• If the use of a guard is recom-
mended for wire brushing, do
not allow any interference of
the wire wheel or brush with the
guard. Wire wheel or brush may
expand in diameter due to work
load and centrifugal forces.
Additional safety instructions
• Never keep the fingers between
the grinding disc and spark pro-
tection or in close proximity to the
guard covers. There is a risk of
crushing.
• The rotating parts of the device
cannot be covered due to func-
tional reasons. Therefore, proceed
cautiously and secure the work-
piece in order to avoid slipping
which could cause your hands to
come into contact with the grinding
disc.
• The workpiece becomes hot dur-
ing grinding. Do not touch the ma-
chined area, allow it to cool down.
There is a risk of burns. Do not use
coolants or the like.
• Do not work with the device if you
are tired or have consumed alcohol
or tablets. Always have a break on
time.
• Switch off the device and remove
the battery. Make sure that all
moving parts have come to a com-
plete stop:
• to loosen a blocked insertion
tool
• in case of unusual sounds
• before checking the device,
cleaning it or performing main-
tenance work on it
• Only use accessories recom-
mended by PARKSIDE. Unsuit-
able accessories may cause elec-
tric shock or fire.

Residual risks

There will always be residual risks
even if you operate this device ac-
cording to the instructions. The fol-
lowing hazards may occur in connec-
tion with the type and design of this
device:
• Eye damage if no suitable eye pro-
tection is worn.
• Lung damage if suitable respiratory
protection is not worn.
• Hearing damage if suitable ear pro-
tection is not worn.
• Health injuries resulting from the
effect of hand/arm vibration in the
event that the tool is used over a
longer period of time or is not used
and maintained properly.
• Damage to health as a result of:
• touching the area of the grinding
tool which is not covered;
• ejection of parts of workpieces
or damaged grinding discs.
WARNING! Danger due to elec-
tromagnetic field generated while the
tool is in operation. Under certain cir-
cumstances, this field may negat-
ively affect active or passive med-
ical implants. In order to reduce the
danger of serious or fatal injuries, we
recommend that individuals who wear
medical implants should consult their
doctor and the manufacturer of the
implant before operating the tool.
GB MT
43