Safety Information - Parkside Performance Pwsap 20-Li F6 Originalbetriebsanleitung

parts of the operating cycle have to
be considered while doing so (for ex-
ample, times when the power tool
is switched off and times when it is
switched on but running without any
load).
WARNING! Grinding thin metal
sheet or other well vibrating struc-
tures with a large surface area can
result in increased noise exposure
and a much (up to 15 dB) higher over-
all noise emission than the specified
noise emission values. Use heavy
flexible damping mats or similar to
prevent sound radiation from such
workpieces. Take into account the in-
creased noise emission and wear ap-
propriate hearing protection.
Charging time
(min.)
PLG 20 A1
PLG 20 A4
PLG 20 C1
PLG 20 C2
PLG 20 A2
PLG 20 A3
PLG 20 C3
PDSLG 20 A1
PDSLG 20 B1
PLG 201 A1
Smart
PLGS 2012 A1

Safety information

This section deals with the basic
safety instructions for using the
device.
WARNING! Injury and property
damage due to improper handling of
Charging time
We recommend that you oper-
ate this appliance with the fol-
lowing batteries only: PAP 20 B1,
PAP 20 B3, Smart PAPS 204 A1,
Smart PAPS 208 A1
We recommend charging these bat-
teries with the following chargers:
PLG 20 A3, PLG 20 A4, PLG 20 C1,
PLG 20 C2, PLG 20 C3, PLG 201 A1,
PDSLG 20 A1, PDSLG 20 B1,
Smart PLGS 2012 A1
Rechargeable battery and charger
technical data: See separate manual.
The charging time is influenced by
factors such as the temperature of
the environment and the battery, as
well as the mains voltage applied,
and may therefore deviate from the
specified values.
PAP 20 A1
PAP 20 A2
PAP 20 B1
60
45
35
135
35
battery. Observe the safety informa-
tion and notes on charging and prop-
er use as shown in the instruction
manual for your battery and charger
from the series X 20 V TEAM. A de-
tailed description of the charging pro-
cess and further information can be
PAP 20 A3
PAP 20 B3
Smart
PAPS 204 A1
120
80
60
250
45
GB MT
Smart
PAPS 208 A1
240
165
120
500
50
35