Preparation; Control Elements; Fitting The Auxiliary Handle; Attaching And Removing The Guard Cover - Parkside Performance Pwsap 20-Li F6 Originalbetriebsanleitung

GB MT

Preparation

WARNING! Risk of injury due to
unintentional start-up. Only insert
the battery into the device once the
device is fully prepared for use.

Control elements

Familiarise yourself with the operating
elements before using the device for
the first time.
Unlock button (13)
• The charge level indicator (11) on
the control panel lights up.
• You can operate the tool until the
charge level indicator goes out.
Speed button (14)
Switch speed level
• 1≙ lowest speed level
• 6 ≙ highest speed level
• The display (12) shows the selec-
ted speed level.
On/Off button (15)
Switching on: Press the On/Off but-
ton twice in quick succession.
Switching off: Press the On/Off but-
ton or the Unlock button.
Spindle lock (8)
• Locks the spindle when attaching/
removing the attachment tool.

Fitting the auxiliary handle

WARNING! Loss of control can
result in injuries! Only operate the ma-
chine with the auxiliary handle at-
tached.
Procedure
1. Turn the auxiliary handle (4) tightly
into one of the holders (9) for the
auxiliary handle.
44
The auxiliary handle can be at-
tached to the tool in the following
positions:
top, left, right.
Attaching and removing the
guard cover
Requirements
• Battery removed from device
• Attachment tool and mounting
flange (27) removed
Fitting the guard cover (Fig. A)
1. Place the guard cover (5) on the
tool so that the open side faces
the tool.
The recesses on the guard cov-
er must fit into the grid (30) on the
tool, only one position is possible.
2. Press and hold the release lever
(31) of the guard cover towards the
device.
3. Turn the guard cover (5) at least ¼
turn.
4. Let go of the release lever (31).
5. Move the guard cover (5) a little
until it clicks into place.
You can now fit an attachment tool.
Removing the guard cover (Fig. A)
1. Press the release lever underneath
the guard cover (31) towards the
tool and turn the guard cover (5)
right until the open side of the
guard cover faces the tool.
2. If the recesses on the guard cov-
er match the grid (30) on the tool,
then you can remove the guard
cover (5) upwards.
Attaching and removing the
attachment tool
Permissible attachment tool
WARNING! Risk of injury! Not any
accessory that can be attached to
your power tool assures safe opera-