Electrical Wiring; Wiring Procedure - Tuthill Fill-Rite 700 Serie Eigentümer-, Einbau-, Betriebs- Und Sicherheitsanleitung

n 7üthi11
Electrical Wiring
WARNING! Electrical wiring should be performed ONLY by a licensed electrician
in compliance with local, state, and national electrical code NEC/ANSI/NFPA 70,
NFPA30, and NFPA 30A, as appropriate
Threaded rigid conduit, sealed fittings, and conductor seal should be used. The
pump must be properly grounded.
result in serious bodily injury, or death!
CAUTION! All pumps should be operated
Power should be supplied to the pump from a dedicated
No other equipment
sufficient size to carry the correct current for the pump.
distance to pump and size of wire; refer to the National Electrical Code (NEC), or
local codes, for Voltage Drop Compensation to be sure you are using the correct
size wire for your application.
Wiring Procedure
WARNING! The
"AUX" lead wire is insulated and enclosed when shipped.
wire without first verifying the "ON" line voltage of the wire for compatibility with
the equipment
"AUX" wire must be insulated
1) Removethe junction box cover and
straighten the wires to make sure the
stripped wire ends are accessible
outside the junction box.
2) Connect the pump wires to the
power supply lines according
diagram. Be certain to properly
insulate the connections
appropriate wire nuts or other
connectors. Note that the ground
wire MUST be connected.
3) Fold the wires back into the junction
box and replace the cover, making
sure the cover gasket is in place.
IMPORTANT!
the gasket for the cover is in
place, and the screws draw
the cover down tight over
the junction box. There must
be no gap between the
junction box and it's cover.
Improper installation
should be powered by this circuit.
"AUX." wire IS A LIVE
to be installed. Maximum
and enclosed
to the
NEUTRAL
with the
GROUND
AUX
Be certain
GROUND
8
to the intended use of the pump.
or use of this pump can
at the Rated Nameplate
20 amp circuit breaker.
Wiring must be of
Voltage drop will vary with
WIRE when the switch
DO NOT connect this
amperage on this wire is 1 amp. The
in the junction box if not used.
115 VOLTWIRING DIAGRAM
ORANGE
AUX
BLACK
AC
WHITE
GREEN
230 VOLT WIRING DIAGRAM
ORANGE
BLACK
AC
BLKIWHT I
AC —p
GREEN
Voltage.
is on! The
MOTOR
MOTOR