Tuthill FILL-RITE 700 Serie Eigentümer-, Einbau-, Betriebs- Und Sicherheitsanleitung Seite 4

7üthill
CAUTION! Do not use additional
proper pressure
reduce rate of flow.
CAUTION! A pressure retaining fill cap can be used to reduce fuel loss through
evaporation, but note that it will reduce the flow rate.
CAUTION! Threaded pipe joints and connections should be sealed with the
appropriate sealant or sealant tape to minimize the possibility
Typical Skid Tank
Installation
Materials:
1-1/4" pipe cut to a
length that will extend to
within 3" of the bottom
the tank when screwed
into the tank adapter
with the tank adapter
screwed into the tank
flange (see SKID TANK
INSTALLATION
diagram).
Threaded pipe joint
sealant appropriate
application.
Installation Procedure:
1) Thread the 1-1/4" pipe
into the tank adapter.
Seal threads liquid tight
with appropriate thread
sealant.
2) Screw the tank adapter into the tank flange; seal threads liquid tight with appropriate
thread sealant.
3) Mount the pump on the adapter; seal threads liquid tight with appropriate
4) Tuthill Corporation recommends installation of an Anti-Siphon Device (see page 7 for
detailed information)
CAUTION! Threaded
appropriate sealant or sealant tape to minimize the possibility
check valves or foot valves unless they have a
relief valve built into them.
SKID
of
for
MAXIMUM LIFT
Gasoline 10' (3m)
Diesel 15' (4.5 m)
pipe joints and connections
4
Note that additional check valves will
of leaks.
TANK INSTALLATION
PUMP
700F0651 ADAPTER
SKID TANK
Additional specifications
should be sealed with the
of leaks.
on page 15.
thread sealant.