Tuthill FILL-RITE 700 Serie Eigentümer-, Einbau-, Betriebs- Und Sicherheitsanleitung Seite 5

Typical Direct Mount Installation
Materials:
2" pipe cut to length
and threaded at both
ends that will extend
approximately 31"
above the ground
when installed in the
tank flange.
1-1/4" pipe cut to a
length that will extend
to within 3" of the
bottom of the tank
when screwed into the
tank adapter with the
tank adapter screwed
into the pipe coupling
(see DIRECT
MOUNTING
INSTALLATION
diagram).
Threaded pipe joint
sealant appropriate
application.
Installation Procedure:
l) Install the 2" pipe in
the tank flange; seal
threads liquid tight
with appropriate
sealant.
2) Screw a 2" standard
pipe coupling onto the
top of the pipe; seal
threads liquid tight
with appropriate
sealant.
3) Screw the 1-1/4" pipe into the tank adapter.
sealant.
4) Screw the tank adapter into the 2" coupling; seal threads liquid tight with appropriate
sealant.
5) Mount pump on tank adapter; seal threads liquid tight with appropriate
CAUTION! Threaded
appropriate sealant or sealant tape to minimize the possibility of leaks.
(to underground
DIRECT
"4Z0.E
for
MAXIMUMLIFT
Gasoivne - 'to'
pipe joints and connections
5
tank)
MOUNTING INSTALLATION
38,'
588—4 555
Additional
Seal threads liquid tight with appropriate
should be sealed with the
7üthill
LEVEL
OF
specifications on page 15.
sealant.