Safety Information; Installation - Tuthill Fill-Rite 700 Serie Eigentümer-, Einbau-, Betriebs- Und Sicherheitsanleitung

Safety Information

WARNING! Electrical
in compliance
NFPA30, and NFPA 30A, as appropriate
Threaded rigid conduit, sealed fittings, and conductor
pump must be properly grounded.
result in serious bodily injury, or death!
WARNING! To insure safe and proper operation of your equipment, it is critical to
read and adhere to all of the following

installation

or use of this product can cause serious bodily injury or death!
14)
NEVER smoke near the pump, or use the pump near open flames when
pumping a flammable
15) A "Fill-Rite" Filter should be used on the pump outlet to insure no foreign
material
16) Threaded
sealant or sealant tape to minimize the possibility
17) Storage tanks should be securely anchored to prevent shifting or tipping
when full or empty.
18) To minimize static electricity
when pumping flammable fluids, and keep the fill nozzle in contact with the
container
19)
The pump motor is equipped with thermal overload protection;
the motor will shut off to prevent damage to the windings.
TURN THE PUMP
warning if the power is on.
WARNING! This product should not be used to transfer fluids into any type of
aircraft.
WARNING! This product is not suited for use with fluids intended for human
consumption or fluids containing water.
Installation
The Fill-Rite Series 700V pump is designed to offer several different mounting configurations.
It can be mounted on a skid tank using the tank adapter supplied with the pump (see attached
diagrams), direct mounted
using an optional pedestal adapter (available through your Fill-Rite distributor).
mounting style, all tanks must be properly vented, and skid tank installations
an anti-siphon device.
The 700V series pump has a built in check valve to reduce unsafe excess pressure from
thermal expansion of the fluid. It also features an integral bypass valve to help minimize wear
when the pump is operating with the nozzle closed.
WARNING! In "Skid Tank" applications,
cannot shift or move when the tank is empty or full.
wiring should be performed
with local, state, and national electrical code NEC/ANSI/NFPA
Improper installation or use of this pump can
liquid! Fire can result!
is transferred to the fuel
pipe joints and connections
build up, use only static wire conductive
being filled during the filling process.
OFF! When the motor
to the top of an underground
3
ONLY by a licensed electrician
to the intended use of the pump.
seal should be used. The
safety warnings and precautions.
tank.
should be sealed with the appropriate
of leaks.
cools, it will restart
tank, or mounted
be sure the tank is properly secured so it
7üthill
70,
Improper
hose
if overheated,
If this happens,
without
on a concrete island
Regardless of
should employ