Repairing; Troubleshooting; Servicing And Repairing The Battery - Stihl Fsa 110.0 R Gebrauchsanleitung

19 Repairing

recommends the following maintenance inter‐
vals:
Every 12 months
► Have the trimmer checked by a STIHL servic‐
ing dealer.
19 Repairing
19.1 Repairing the Trimmer and
Cutting Attachment
The trimmer and cutting attachment cannot be
repaired by the user.
► If the trimmer or cutting attachment is dam‐
aged: Do not use your trimmer or cutting

20 Troubleshooting

20.1 Troubleshooting the brushcutter or battery
Error LEDs on the
battery
The brushcutter 1 LED flashes
does not start green.
when switched
on.
1 LED lights
up steady red.
3 LEDs
flash red.
3 LEDs light
up red.
4 LEDs flash
red.
The brushcutter 3 LEDs light
cuts out during up red.
operation.
0458-064-9601-A
attachment and contact your STIHL servicing
dealer.
19.2
The battery requires no servicing and cannot be
repaired.
► If the battery has a malfunction or is damaged:
Replace the battery.
Cause
The state of charge of
the battery is too low.
The battery is too
warm or too cold.
The brushcutter has a
malfunction.
The brushcutter is too
hot.
There is an error in
the battery.
No electrical contact
between brushcutter
and battery.
The brushcutter or
battery is damp.
Trigger is depressed
before operating the
release slide.
The brushcutter is too
hot.
There is an electrical
error.
Servicing and Repairing the
Battery
Remedy
► Recharge the battery fully as described in
the user manual for the STIHL AL 101,
301, 301-4, 500 chargers.
► Remove the battery.
► Allow the battery to cool down or warm
up.
► Remove the battery.
► Clean the electrical contacts in the bat‐
tery compartment.
► Insert the battery.
► Switch on the brushcutter.
► If 3 LEDs continue to flash red: Do not
use the brushcutter and contact a STIHL
authorized dealer for assistance.
► Remove the battery.
► Allow the brushcutter to cool down.
► Remove the battery and reinsert it.
► Switch on the brushcutter.
► If 4 LEDs continue to flash red: Do not
use the battery and contact a STIHL
authorized dealer for assistance.
► Remove the battery.
► Clean the electrical contacts in the bat‐
tery compartment.
► Insert the battery.
► Allow the brushcutter or battery to dry,
21.4.
► Switch on the brushcutter as described in
this User Manual.
► Remove the battery.
► Allow the brushcutter to cool down.
► Remove the battery and reinsert it.
► Switch on the brushcutter.
English
37