Werbung
Verfügbare Sprachen
Verfügbare Sprachen
22
JT MINI
· ·
Once the sequencer is running you
can play the notes as required.
They will automatically quantize to
the nearest step.
· ·
In PLAY mode you can erase the
current sequence by holding FUNC
and pressing ERASE (27).
· ·
When you have finished recording
press PLAY (28) to stop the
sequencer. Hold the FUNC button
and press WRITE (26) followed by a
key between 29 and 38 to write to
memories 1 – 10. Note that control
settings are not saved.
Using freestyle in the sequencer
At any point while programming a
sequence you can hold the FUNC button
and press key 36 to enter Freestyle
mode. In this mode the quantization
is turned off, and the sequencer will
effectively record your input in real
time. Repeating FUNC and 36 reverts
to quantized programming, and any
notes falling between steps will be lost,
unless you switch Freestyle back on.
Using motion sequencing in
the sequencer
While recording a sequence holding
the FUNC button and pressing Motion
Sequence On /Off (Key 37) allows you
to record the movement of any of the
JT MINI's controls (except Scale, Mode,
Waveform and Resonance) as part of
the sequence. Note that base control
settings are not stored. Pressing FUNC
and Smooth (Key 38) interpolates
values to smooth out your adjustments,
otherwise they will change suddenly
with the sequence steps. To clear your
motion sequence press FUNC and CLEAR
(Key 39).
Using the arpeggiator
· ·
Select the required arpeggiator
mode using Control 10 (Up, Down,
Up & Down, Random)
· ·
Either hold down the required keys
on the JT MINI's keyboard, or send
them over MIDI
· ·
To exit the arpeggiator set Control
10 back to Poly or Unison for normal
keyboard operation
Menu functions
The JT MINI has menu functions that are
accessed by powering up while holding
different buttons:
MEMORY/WRITE (26) – sets the MIDI
channel using keys 29 – 44.
PLAY/ACTIVE (28) & FUNC (3) –
initiates a VCO calibration routine.
MEMORY/WRITE (26) & FUNC
(3) – Restore factory parameters.
Press Record (27) to restore, Play (28)
to cancel.
MEMORY/WRITE (26) & RECORD (27) & PLAY (28) & FUNC (3) –
initiate firmware update from SynthTribe app.
FUNC (3) & KEYS
Pressing FUNC while powering up the JT MINI allows the following parameters
to be set:
Key No.
Action
Auto power off, JT MINI will power down after two hours
1
with no activity (LED on).
Sync out clock polarity. Toggle between rising and falling.
2
LED on indicates falling; off indicates rising.
Sync in clock polarity. Toggle between rising and falling.
3
LED on indicates falling; off indicates rising.
Tempo Band. Toggle between wide (10 - 600 bpm, LED off)
4
and narrow (56 – 240 bpm, LED on).
5
Clock Source Internal.
6
Clock Source DIN MIDI.
7
Clock Source USB MIDI.
8
Clock Source External Sync.
9
1 pps.
10
2 ppqn.
11
24 ppqn.
12
48 ppqn.
MIDI Rx On/Off - when MIDI Rx is ON the JT MINI will receive
MIDI note on/off messages from an external MIDI device,
13
even if the sequencer is running. When it is OFF these
messages will not be received.
23
Quick Start Guide
Werbung
