Time-Out Mode - Smartwares Rm 250 Montage-, Bedienungs- Und Sicherheitshinweise

both catches of the base plate
the smoke detector
clockwise until it clicks audibly.
After installing the smoke detector
button
1
section "Activating the device").

Time-out mode

mode if the cause of the alarm has definitely been located
and no further hazard exists.
First, try to locate the potential cause of the alarm. If nec-
essary, the smoke detector
mode using the test button
of the smoke detector
3
Eliminate the source of smoke. After ten minutes, the smoke
detector will automatically return to standard mode.
2
GB/IE
62
and turn the smoke detector
2
to check that it functions correctly (see the
Only switch the device to time-out
2
1
2
into the recesses of
7
press the test
2
can be switched to time-out
. In time-out mode, the LED
will flash every ten seconds.