PROTEOR synsys 1P700LEG Gebrauchsanweisung Seite 45

Cleaning
Clean the prosthesis using a wet soft cloth and mild
soap, following exposure to dust or moisture. In
particular, keep the articulated area of the knee clean
(magnet). Take care with the small mobile covers (access
to socket for charging). Never use any solvents, which
could damage the device. Check that there are no metal
particles on the magnetic connector and the articulated
area.
In case of high perspiration in the socket, and use of vacuum suspension, make sure the
prosthesis does not get excessively wet.
Care, maintenance, and service life
Electrical network compatible with charger 1P700234-S (manufacturer: PROTEOR):
Input current: 0.3A max. at 100VAC
Input voltage: AC 100-240 V
Low Power Supply (LPS) compliant
Degree of protection: IP21
Compatibility with standard Bluetooth v2.1 + EDR – class 2 (2.5 mW)
[2400 – 2483.5] MHz
EMC emission class:
Class B – use in residential environment as per standard IEC 60601-1-2. Immunity
test level = 12v/m (as per standard EN22523).
Degree of protection as per standard IEC 60529:
IP54:
On request, your orthopedic prosthetist will tell you the prosthesis software reference and
version.
The device must undergo a check by your certified prosthetist at least once a year.
Service life: 3 to 6 years, depending on activity level.
The device needs to be replaced after 6 years' use or after 3 million steps.
If the predicted service life is exceeded, the risk of device failure is increased. This device is
prescribed for one user only; any resale is prohibited.
This device is made of components made from various materials: elastomer, plastic, composite
(carbon fiber), aluminum, titanium, steel, brass. It also contains oil, a Lithium-ion battery and
electronic components, which must not be disposed of with household waste. Avoid any
contact with oil. At the end of the device's life, return it to your certified prosthetist.
Protected against dust and other microscopic residue.
Protected against water splashes from any directions.
Output current: 2A max.
Output voltage: 5V DC
Frequency: 50-60 Hz
EN - 20