Scheppach PM1800D Originalbetriebsanleitung Seite 27

15. Troubleshooting
Problem
Motor does not start.
Unusual vibrations
Device starts but blocks
under slight load and cuts
off automatically.
Possible cause
No power supply (power failure)
Mains cable defective.
Motor or switch defect
Beater defective.
Chuck defective.
Non-intended material to be mixed.
Extension cable too long, or crosssec-
tion too small.
Socket too far away from main connec-
tion, and cross-section of connection
lead too small.
www.scheppach.com
Remedy
Check fuses
Exchange defect cable, respectively
check extension cable, (by electrician)
Never use defect lead
To correct the problem, refer to the
manufacturer or other approved ser-
vice centre.
Replace the beater.
To correct the problem, refer to the
manufacturer or other approved ser-
vice centre.
Incorrect processing. Follow the pro-
cessing instructions from the supplier.
Extension cable at least 1,5 mm
maximum 25 m long.
Cross- section of at least 2,5 mm
longer cables.
,
2
in
2
GB | 27