Scheppach PM1800D Originalbetriebsanleitung Seite 25

• Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plastic
parts in the equipment. Ensure that no water can
get into the interior of the equipment.
• In order to extend the service life of the tool, oil
the rotary parts once monthly. Do not oil the motor.
Brush inspection
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important. The carbon brushes should not be replaced
by anyone but a qualified electrician.
11. Repair & ordering spare parts
After any repair or maintenance work, make sure that
all safety-related parts are in place and in perfect
condition. All parts which may cause injury must be
kept where they are inaccessible to children or others.
Attention: According to the German Product Liability
Act, no liability is accepted for damage caused by
improper repairs or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialist. The same applies to
accessory parts.
Connections and repairs
Connections and repair work on the electrical
equipment may only be carried out by electricians.
11.1 Ordering spare parts
Please provide the following information when
ordering spare parts:
• Model designation
• Article number
• Type plate data
Spare parts / accessories
Carbon brushes - Article no:
Mixing rod - Article no:
11.2 Service information
With this product, it is necessary to note that the
following parts are subject to natural or usage-related
wear, or that the following parts are required as
consumables.
Wearing parts*: Carbon brushes, Mixing rod
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
12. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions.
The customer's mains connection as well as the
extension cable used must also comply with these
regulations.
• The product meets the requirements of EN 61000-
3-11 and is subject to special connection conditions.
This means that use of the product at any freely
selectable connection point is not allowed.
• Given unfavorable conditions in the power supply
the product can cause the voltage to fluctuate
temporarily.
• The product is intended solely for use at connection
points that
• a) do not exceed a maximum permitted supply
impedance "Z" (Zmax = 0,355 Ω) or
b) have a continuous current-carrying capacity of
the mains of at least 100 A per phase.
• As the user, you are required to ensure, in
consultation with your electric power company if
necessary, that the connection point at which you
wish to operate the product meets one of the two
requirements, a) or b), named above.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been
improperly fastened or routed.
5907802001 • Places where the connection cables have been cut
5907802701 due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
www.scheppach.com GB | 25