Spring 5898433531 Gebrauchsanweisung Seite 27

11 Troubleshooting
Disorder
The appliance does not switch on.
The appliance does not heat.
The appliance suddenly stops the
operation.
The heating level is too low.
The remote control does not work.
Possible cause
1. No / insufficient supply voltage.
2. Internal defect.
1. The cookware is not suitable for
induction or the bottom diameter
is too small.
2. The cookware does not cover
any of the induction coils
sufficiently.
3. The overheat protection is
activated.
4. Internal defect.
1. The overheat protection is
activated.
2. Internal defect.
1. The cookware does not have
a flat bottom or is made of
unsuitable material.
1. The distance to the induction unit
is too high.
2. The battery is empty.
3. Internal defect.
Troubleshooting
1. Plug the cord into a suitable
socket. Make sure the socket
has the correct voltage.
2. Contact your sales or service
office.
1. Use appropriate
according to chapter 5.4.
2. Readjust the position of the
cookware on the glass ceramic
plate.
3. Allow the appliance to cool
down.
4. Contact your sales or service
office.
1. Assure that the cookware is not
empty. Remove it carefully from
glass ceramic surface and
allow the appliance to cool
down. Ensure unobstructed air
circulation. Make sure according
to chapter 7 that the exhaust air
openings are free of soiling.
2. Contact your sales or service of-
fice.
1. Use appropriate
according to chapter 5.4.
1. The distance between the
remote control and appliance
should not exceed 1 m.
2. Replace the battery.
3. Contact your sales or service
point.
cookware
cookware
27