Starting The Engine; End Of Work - Scheppach HS720 Originalbetriebsanleitung

Starting the engine

Follow the procedures below for a cold start:
1. Open the fuel valve (B) to the right in the ope-
ning position.
2. Turn the choke lever (A) on the engine to fully
activated position to the left.
3. Move the throttle lever (C) on a semi-open po-
sition.
4. Turn the ignition switch (E) to ON.
5. Pull slowly several times the reverse starter
handle (D) so that the fuel flows into the car-
burettor. Then hold the reverse starter handle
(D) and pull the cable out slightly until you feel
resistance. Then pull the cable in a quick moti-
on and let the cable rewind slowly again. Do not
allow the cable to snap back. Tighten if neces-
sary, the reverse starter handle (D) repeatedly
until the engine starts.
6. Let the engine warm up for a few seconds. Then
gradually move the choke lever (A) to the right
in the „OPEN" position.
The restart of an engine that is already hot from the previous operation usually does not require use of the choke.
1. Open the fuel valve (B) to the right in the opening position.
2. Move the throttle lever (C) on a semi-open position.
3. Turn the ignition switch (E) to ON.
4. Then hold the reverse starter handle (D) and pull the cable out slightly until you feel resistance. Then pull the reverse
starter handle (D) in one swift movement and leave the cable to wrap back slowly. Do not allow the reverse starter
handle (D) to snap back.
After the engine starts, move the throttle lever (C) to full throttle position, so that the splitter can achieve its maximum
working force.

End of work

• Turn off the machine by turning the ignition switch (E) to OFF.
• Close the fuel valve (B)
• Observe general maintenance instructions.
• Place the jack in the transport position and secure it with the locking lever
Sawing
1. Turn on the machine.
2. Wait until the saw blade has reached full speed.
3. Put the wood on the rocker.
4. Take hold of both handle bars of the rocker with both hands and lead it evenly to the saw blade; thus the saw blade is re-
vealed.
5. Push the rocker evenly to ensure the engine speed does not drop.
6. Remove the sawn wood from the rocker before putting on the next piece.
ATTENTION!
Do not leave the machine unattended during operation.
Turn off the machine if you discontinue working, and unplug the spark plug.
Seite:26
A
B
D
C
E