Scheppach HS720 Originalbetriebsanleitung Seite 21

• The Scheppach machine may only be used, maintained, and operated by persons familiar with it and instructed in its operation and
procedures. Arbitrary alterations to the machine release the manufacturer from all responsibility for any resulting damages.
• The Scheppach machine may only be used with original accessories and original tools made by the manufacturer.
• Any other use exceeds authorization. The manufacturer is not responsible for any damages resulting from unauthorized use; risk is the
sole responsibility of the operator.Remaining hazards.
m
Ohter risks
The machine has been built using modern technology in accordance with recognized safety rules. Some remaining haz-
ards, however, may still exist.
• The rotating saw blade can cause injuries to fingers and hands if the work piece is incorrectly fed.
• Thrown work pieces can lead to injury if the work piece is not properly secured or fed.
• Noise can be a health hazard. The permitted noise level is exceeded when working. Be sure to wear personal protective
gear such as ear protection.
• Defective saw blades can cause injuries. Regularly inspect the structural integrity of saw blades.
• The operating instructions supplied with the special accessories must be observed and carefully read when Scheppach
special accessories are used.
• Even when all safety measures are taken, some remaining hazards which are not yet evident may still be present.
• Remaining hazards can be minimized by following the instructions in "Safety Precautions", "Proper Use" and in the
entire operating manual.
Attention: risk of accident!
The wood must always be seated on both sides of the saw blade on the v-block of the rocker. (see arrows)
Scope of delivery
Rocker circular saw
Female six fold wrench or open-end wrench
Locking pin
Operational instructions
Seite:21