cecotec CONGA 13090 SPIN REVOLUTION HOME&WASH Bedienungsanleitung Seite 40

ENGLISH
- In addition, the charging base has two charging terminals that can be dusty and dirty. Wipe
them with a clean, soft, dry cloth.
Charging and replacing the battery
- To extend battery life, leave the robot vacuum cleaner charging on the self-emptying base
whenever not in use.
- Remove the battery and store it in a safe, dry place if the robot vacuum cleaner will not be
used for a long period of time.
1. To replace the battery, follow the instructions below:
2. Unscrew the screws on the bottom battery cover, remove the cover and remove the
battery.
3. Insert the new battery.
4. Replace the battery and the lower casing and refasten the screws.
5. TROUBLESHOOTING
Robot vacuum cleaner
Problem Possible cause and solution
The robot vacuum cleaner does The robot vacuum cleaner does not work when battery
not switch on or does not clean is low. Charge it before operation.
The room temperature is below 0 °C or above 40 °C.
The robot vacuum cleaner isn't There are too many obstacles near the self-emptying
charging or returning to the self- base. Relocate the base to an obstacle-free area.
emptying base
Clean the charging terminals of the robot vacuum
cleaner and the self-emptying base.
Make sure the robot vacuum cleaner is switched on.
The robot vacuum cleaner is too far away from the
self-emptying base. Place it closer and try again.
The robot vacuum cleaner does Turn off the robot vacuum cleaner and turn it on again.
not work properly
Reset the robot vacuum cleaner by pressing the side
Reset button.
78
CONGA 13090 SPIN REVOLUTION HOME&WASH
The robot vacuum cleaner The main brush, side brush, or omnidirectional wheel
makes a strange noise during are blocked or tangled. Stop the robot vacuum cleaner
operation and clean them.
The robot vacuum cleaner does The high-efficiency filter is blocked. Clean it.
not clean efficiently or doesn't
The main brush is blocked or tangled. Clean it.
pick up all the dirt
The dirt tank is full, empty it.
The robot vacuum cleaner could Bad Wi-Fi signal. Check that the robot vacuum cleaner
not connect to the Wi-Fi network is located in an area with good Wi-Fi signal.
The Wi-Fi connection is unstable. Reset the router,
check if there are any App updates, and try again. This
robot vacuum cleaner only supports the 2.4 GHz band.
Make sure that your smartphone mobile data are
disabled to improve the pairing process.
The robot vacuum cleaner did Check if the robot vacuum cleaner is in Sleep mode
not carry out the scheduled and change mode. This option can be found on the
cleaning task general settings of the robot vacuum cleaner and
allows you to define time slots in which the robot will
not perform the scheduled cleaning tasks when in
Sleep mode.
Make sure the robot vacuum cleaner is plugged to the
mains, that it will not be able to carry out scheduled
cleanings offline, and that the battery is not low.
The robot vacuum cleaner does The robot vacuum cleaner will map and calculate a
not return to the self-emptying new route after running in Spot cleaning mode or after
base after finishing Spot changing its starting position.
cleaning or changing the starting
If the self-emptying base is too far away from the
position
robot vacuum cleaner, the latter won't be able to
return to the base. Manually move the robot vacuum
cleaner close to the base.
ENGLISH
CONGA 13090 SPIN REVOLUTION HOME&WASH
79