Parkside PGHSA 12 C2 Bedienungsanleitung Und Originalbetriebsanleitung Seite 47

5. The chain is worn and must be replaced by
a new saw chain if only approx. 4 mm of the
cutting teeth is remaining.
6. After the sharpening, all cutting elements must
now be equal in length and width.
7. After every third sharpening, the sharpness
depth (depth limitation) must be checked and
the height filed with the aid of a flat file. The
depth limitation should be set back about
0.65 mm from the cutting tooth. After the
setting back of depth limitation, round it off a
little at the front.
˜ Adjusting the chain tension
The adjustment of the chain tension is described in
the chapter "Assembly - tensioning chainsaw".
Switch off the product and remove the battery
from the product.
[ 14 ]
Check the chain tension regularly and re-
adjust this as often as possible. When the saw
chain is tensioned with 9 N (approx. 1 kg),
the gap between the saw chain and the guide
rail may not be more than 2 mm.
˜ Starting up a new saw chain
In the case of a new chain, the tensioning force
decreases after some time. Therefore, you have
to re-tension the chain after the first 5 cuts and no
later than after 10 minutes' sawing time.
WARNING!
m
Never attach a new chain to a worn drive
u
pinion or place onto a damaged or worn
chain bar. The chain could spring back or
break, potentially leading to serious injury.
˜ Maintaining the chain
1. Use cut-protection gloves when handling the
chain or the chain bar.
2. Switch off the product and remove the battery
from the product.
[ 14 ]
3. Remove the sprocket chain wheel covering
, the saw chain
[ 9 ]
4. Check the chain bar
5. Remove burrs and straighten the guide
surfaces with a flat file.
46 GB/IE
and the chain bar
12 ] [ 11 ] [
for wear.
11 ] [
6. Mount chain bar
sprocket chain wheel covering
the chainsaw.
˜ Turning the blade bar
m WARNING!
Use cut-resistant gloves when working with
u
the saw chain or with the blade bar.
The blade bar
11 ] [
after a working time of about 10 hours in order to
ensure even wear.
1. Switch off the product and remove the battery
pack from the product.
14 ] [
2. Remove the sprocket cover
and blade bar
3. Turn the blade bar around its horizontal
axis and install the blade bar and chain as
described under "Installing the saw chain and
blade bar". When doing so, pay attention to
the correct rotation direction of the saw chain!
˜ Replacement parts /
Accessories
Compatible replacement parts for this device can
be purchased at www.Optimex-Shop.com. Please
have the order-no. ready for your order. Orders
can only be placed and processed online. If you
are not sure where you can purchase compatible
parts, please contact the Lidl Service Hotline.
Position Description
11 6" blade bar
12 Saw chain
13 Blade encasing
Customers can obtain compatible replacement
batteries and chargers from the LIDL online shop
www.lidl.de.
˜ Storage
Clean the equipment before putting it away.
Put on saw bar protection sheath.
.
Store the appliance in a dry place well out of
reach of children.
, chainsaw and
11 ] [ [ 12 ]
and tighten
9 ] [
needs to be reversed regularly
, saw chain
9 ] [
.
11 ] [
Order-No
944399802
944399803
944399804
12 ] [