Bosch BTH-RAD Bedienungsanleitung Seite 16

Radiator thermostat II [+M]
Flashing codes and displays
The status LED (C) and the display (B) provide useful information during
start-up and operation.
During start-up on a third-party Matter Smart Home system
Display Status LED
–
–
Flashes blue
every 1.5 s
Flashes orange
every 1.5 s
– Flashes green once
– Flashes red once
–
–
↑Contents
8-750-002-924 | V001 | 08/2024
Device status
Device is starting.
Switch to Matter mode
successfully.
Matter pairing mode
is active. Device ready
for coupling to a Matter
Smart Home system.
The device is currently in
ZigBee mode.
Coupling with Matter
system successful.
Coupling with Matter
system failed.
Device is ready for
calibration.
Device calibration is in
progress.
Recommended action
Please wait until the process is
completed.
–
Couple the device with the
Matter system according to the
instructions.
For pairing with a Matter system,
Matter mode must be set.
To do this, press ○ ○ for > 5 s until
the status LED flashes blue.
The device can now be paired
with the Matter system.
–
Reset the device to factory
settings and start the process
again
Fit the thermostat to the heating
valve.
Press ○ ○ to start the calibration.
Wait until the process is complete
and the room temperature is
displayed.
Bosch Smart Home
English | 16