Bosch BTH-RAD Bedienungsanleitung Seite 10

Radiator thermostat II [+M]
Mounting instructions
݃ Property damage owing to defective heating system!
Mounting of the product on defective heating systems may result in
damage to the product itself (e.g. owing to leaking hot water). Have an
expert repair damage to the valves or to the heating system. Observe the
maintenance intervals for your heating system including valves.
݃ The standards and directives applicable in your country must be
observed during planning, set-up, operation and maintenance.
݅ Mounting of the radiator thermostat is simple and can be done without
draining the heating water or interfering with the heating system. Special
tools or switching off the heating are not required.
݅ For some heating models, you need one of the adapters supplied or you
need to purchase a specific adapter from a shop. For a detailed list of
compatible radiator valves and information on required adapters, see:
→ https://www.bosch-smarthome.com/radiator-thermostat-adapter
݅ Take care not to catch your fingers when screwing on the adapter!
Typical assembly sequence
with one adapter
݅ No tools are required to mount the radiator thermostat on the valve or
adapter. Tighten the nut of the thermostat on the thread of the valve or
adapter by hand. Hold the device firmly in the desired orientation. Take
care not to tilt the nut when tightening it. This could damage the thread.
‫ ܬ‬You can also view the explanatory videos and additional information
on our website for further help with mounting, installing, starting up
and restoring the factory settings on your Bosch Smart Home radiator
thermostat II [+M]:
→ https://www.bosch-smarthome.com/radiator-thermostat-2d
↑Contents
8-750-002-924 | V001 | 08/2024
English | 10
Bosch Smart Home