Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
CLEANING AND MAINTENANCE
CAUTION! Disconnect the device from the mains and wait until it cools down before
cleaning!
CAUTION! Do not submerge the device in water or other liquids.
CAUTION! Remove all accessories before cleaning the device.
CAUTION! The knife's blades are sharp. Handle them with extreme care.
1. The device and its accessories must be cleaned after every use. This guarantees its full oper-
ating capability.
2. When cleaning it, do not use aggressive cleaning agents, solvents or hard, abrasive materials
that would scratch the surface.
3. Clean the device's housing (8) with a damp cloth and then wipe it with a dry one. Use a damp
cloth with cleaning agents for stubborn dirt.
4. You can pre-wash the inside of the bowl by pouring about 0.6l of water with detergent into it
and setting the knife speed to 6 for about 30 seconds. This operation is enough to initially clean
the inside of the bowl, but it still needs to be washed thoroughly. Alternatively, the program
PRE-WASHING can be used. Remember to check carefully that the knife is properly seated
on the drive shaft and that there are no food residues under the knife before pre-cleaning.
The stirrer and butterfly should not be used in the pre-wash programme.
5. If there are any signs of burnt grime in the bowl, pour in some water and citric acid solu-
tion and wait a few minutes. The plastic (black) elements of the bowl, lids and accessories
may become discoloured if too much citric acid is used. This has no effect on the device's
operation.
6. Remove all accessories (Fig. 9), wash in warm water with cleaning agent, rinse and dry thor-
oughly. The accessories can be also washed in a dishwasher. Please note that the bowl (8)
and the drive shaft (24) installed in the bowl (Fig. 9) must not be washed in a dishwasher. The
bowl contains electrical components that may accumulate condensation and become dam-
aged if washed in a dishwasher.
7. Make sure the rubber seals (3), (15) and (23) are clean and correctly seated. The seals may
be removed and washed independently, but must be then correctly re-seated. The seals are
of different dimensions and are not interchangeable.
8. Store the device in a dry place that is not exposed to the sun. Place the device in a card-
board box for longer storage.
9. The bowl features an overheating protection. If the temperature in the bowl exceeds a cer-
tain, safe level, the bowl's heating function will be deactivated until the bowl's thermal pro-
tection is reset. The protection reset button is located in the bowl's bottom part (Fig. 10).
Use the tip of a small screwdriver or a pen to press the button. Do not use any sharp tools
to do that. An audible click indicates that the protection has been reset.
Before resetting the protection, please note that:
- overheating may result from the failure to use the knife or the stirrer, cooking with an empty
bowl or cooking at an excessive temperature or for too long. Never let the food get burnt in
the bowl. If the food is starting to get burnt, reduce the temperature and add some water
or grease.
- Empty the bowl and let it cool down before resetting the protection.
- Never place the bowl in the fridge.
48
Werbung
