Tamiya RM-01 Bedienungsanleitung Seite 23

ü-g-D
Stickers
@ Cut along the edges as close as
possible to cut the sticker from the
Sheet. Cut out stickers in numbered
order to prevent confusion.
@ Slightly peel away one end of the
lining and position the sticker on the
body.
@ Slowly remove the remaining lining
while checking sticker position. Do not
completely remove lining prior to appli-
cation as this may cause unwanted
bubbles and creases.
o
o
Actual size
Double-sided tape (Black)
Double-sided tape (Black)
Double-sided
Double-sided tape
tape @
Modifying snap pins
*Apply
Markings
($0
air
9
Attaching driver figure
—S
b
*Match to hole
positions on the body.
Attaching rear wing
stickers in numbered order.
(43)
6
HANSSON
M.S.SAL+
(40
[l
6
4
right
*Attach body parts with double-sided tape. Cut tape
into the sizes shown.
7
(14)