Alde Compact 3030 Gebrauchsanweisung Seite 51

Automatic climate control is not working satisfactorily
• There are two heating zones in a dual-zone system, but only one zone for cooling. In this case,
set the AC to follow the thermostat in one of the zones. When the AC-controlled zone indicates a
need for cooling, heating will be switched off in the other zone. This is to avoid unnecessary energy
consumption.
Ensure that the zone selected to control the AC reacts effectively to room temperature for high and
low temperatures. If the AC will not cool due to low outdoor temperature, the outdoor sensor can be
temporarily disconnected to test the AC.
• Fitting an outdoor temperature sensor (part number 3010299) improves climate technology, but note
that if the outdoor temperature is too low, the AC will not run.
Note that in or out of night mode and day mode, the system will wait to see if there is a need to
switch from cooling to heating or vice versa. This is to avoid unnecessarily large temperature
variations in the vehicle.
11. Service menu & resetting
Tap Service Information to reach the service menu (Fig. 22).
The values from the heating system are shown here (see Fig. 23); the values are updated continuously.
Reset
Tap Reset (Fig. 22) to reset the Control Panel to factory settings. After resetting, the system will be set
as follows:
• Heater - Off mode/ Boiler - Off
• Max. electricity - 1 kW/ Max. electricity - 1 kW
• Gas heating - On mode
• Target temperatures - 22.0 °C/ Temperature setting - 22.0 °C
• Hot water - In normal mode
All other functions will be switched off. The accessories/functions selected under ""System configuration"
are not affected by resetting.
Reset
Fig. 22. Control Panel menus
Service, page 1
Fig. 23. Service Information
Service, page 2
51