Alde Compact 3030 Gebrauchsanweisung Seite 38

5. Starting the heating system for the first time
1. Start the heating system by pressing the On/Off button on the control panel (Fig. 3, item 1).
When the heating system and control panel are on, a green diode lights up on the On/Off button.
2. Select language.
3. Press the Configure button to go to System Configuration. You can always reach this menu by
pressing the menu button on the Alde Control Panel and scrolling until the System Configuration
option arrives.
4. If you have a dual zone system, go to the second page in System Configuration and select 2-zone
mode.
The relevant accessory is highlighted if connected:
Pump, 12 V pump. Select Manual if there
is a selector on the pump, otherwise
PWM.
Booster fan.
Underfloor heating, 12 V pump for under-
floor heating.
Engine pre-heat. Heat the engine using
the Alde heating system.
Extra hot water tank/Alde Flow,
for increased hot water capacity and
continuous hot water. (Not 3030 Plus)
5.
Single-zone system
• Browse through system configuration, activate any accessories/functions fitted using their respective
menus. (Fig. 3)
• Go back using the Back arrow in the top left corner, and select Done.
• To change the desired indoor temperature from the status screen, press the menu button multiple times
until you reach the temperature setting menu and set the temperature there. (Fig. 4)
Raise or lower the temperature using the plus and minus buttons.
1
Fig. 3. single zone
38
DuoControl, Bottle Switch.
EisEx (Defroster).
Alde AquaClear UV-C.
Remote Control (Ex. Alde Voice Control,
Alde Smart Control).
2-Zone mode (if you have two tempera-
ture zones installed).
Fig. 4. single zone