Parkside Performance PASSP 20-Li C4 Originalbetriebsanleitung Seite 19

˜ S i i
WARNING! Risk of injury due
m
to unintentional continuous
operation of the product!
Be ore in ertin the atter pa k
u
he k that the on o
works properly and returns to the
OFF position when released.
Switching on
1. In ert the atter pa k
In ertin removin the atter pa k .
2. Set the rotational direction (see
Settin the rotational dire tion .
3. Select the speed level (see "Selecting
the peed level .
4. Pre and hold the on o
S i i
1. Relea e the on o
2. Wait until the product has stopped
before placing it down.
3. When taking a break: Push the
rotational dire tion
middle position. This prevents the
product from being switched on
accidentally.
4. Remove the atter pa k
product if you are leaving the product
unattended or i
working.
˜ Speed control
Progressively controlling the speed:
o
Apply gentle or stronger pressure on
the on o it h
Pressure
Gentle
Strong
18 GB
[ 7 ]
it h
[ ]
(see
7 ] [
it h .
[ ]
it h .
[ ]
it h to the
2 ] [
from the
[ 7 ]
ou have ni hed
.
[ ]
Speed
Low
High
˜ LED work light
NOTE
Improve visibility in poorly lit areas:
u
This product is equipped with a
LED ork li ht
,
immediate working area.
As soon as the product is switched
o
on The LED ork li ht
immediately.
˜ Belt clip
CAUTION! Risk of injury!
m
Before hanging the product on a
u
belt: Push the rotational direction
it h
2 ] [
This prevents the product from being
switched on accidentally.
Hanging the product on a belt: Use the
o
elt lip
6 ] [
You an u e the elt lip
o
opener for bottles with crown caps.
˜ Working instructions
NOTICE!
m
Always follow the manufacturer's
u
instructions for tightening screws
or nuts. Follow the manufacturer's
guidelines for the inspection of
screws or nuts in accordance with
time or performance.
A ter han in a vehi le
u
Inspect the wheel bolts or nuts as
requested in the manufacturer's
instructions or guidelines. Tighten
the wheel bolts or nuts with a torque
ren h a ter approx. 0 to 100 km.
The tightening torque depends on the
o
impact duration.
In order to achieve optimum impact
o
force, do not exert any pressure
against the screw/nut.
to illuminate the
[ ]
switches on
[ ]
to the middle position.
.
as a bottle
6 ] [
heel