Parkside Performance PASSP 20-Li C4 Originalbetriebsanleitung Seite 16

˜ Residual risks
Even if you are operating this product
in accordance with all the safety
requirements, potential risks of injury and
damage remain. The following dangers
can arise in connection with the structure
and design of this product:
Injuries caused by moving parts or hot
surfaces
Ear damage if working without ear
protection
Damage to your health caused by
swinging your hands and arms when
operating the product for longer
periods of time or if the unit is not held
or maintained properly
NOTE
This product produces an
u
ele troma neti
operation Thi
some circumstances interfere with
active or passive medical implants!
To reduce the risk of serious or fatal
injury, we recommend persons with
medical implants to consult their
doctor and the medical implant
manufacturer before operating this
product!
˜
˜ Unpacking the product
1. Take the product out of the packaging
and remove all packaging materials
and plastic wrappings.
2. Check to make sure that all listed parts
are in luded ee "S ope o deliver " .
3. Check whether the product and all
parts are in good condition, if any
damage or defect is detected, do
not use the product, but follow the
procedure described in chapter
"Warranty".
eld durin
eld ma under
˜ Accessories
WARNING!
m
Do not use accessories not
u
recommended by
ma re ult in ele tri
To operate this product safely and
correctly, the following accessories are
necessary:
Suitable personal protective equipment
o
For screwing in and loosening screws, the
following accessories are necessary:
Bit holder for
1
2
o
holder
1 ] [
Screw bit
o
Accessories and accessory tools are
available through your authorised dealer.
When buying always consider the
technical requirements of this product
ee "Te hni al data" . I
ertain a k a uali ed pe iali t and et
advice from your trusted dealer.
˜ Preparation
WARNING! Risk of injury due to
m
i i
Onl in ert the atter pa k
u
the product is fully prepared for use.
˜ Attaching/removing an
insertion tool
NOTE
The directional information in this
u
section should be interpreted as
meaning that the user is positioned
behind the product.
Tool holder:
u
drive.
Insertion tool: Socket/Socket
u
adapter (
1
2
1 mm .
3
4
. This
ho k or re.
12. mm tool
ou are not
-
once
7 ] [
12. mm uare
1
2
12. mm to
GB 15