Silvercrest SEMP 2000 A1 Kurzanleitung Seite 16

Make sure that the device is switched
off before you connect it to a wall sock-
et (thermostat control is set to OFF).
Only use the original accessories.
Only use utensils made from wood or
heat-resistant plastic. Metal cutlery can
damage the coated surface of the frying
pan.
Do not cut up any food in the pan.
Do not use any astringent or abrasive
cleaning agents.
The device is fitted with non-slip plastic
feet. As furniture is coated with a wide ar-
ray of varnishes and synthetics, and is
also treated with different care products,
it cannot be fully ruled out that some of
these materials contain components that
could attack and soften the non-slip plas-
tic feet. If necessary, place a non-slip mat
under the device.
If you want to fry at the table, please note
that splashes of fat can damage the ta-
ble, the tablecloth and clothing.
How to use
Unpacking
• Remove all packing material.
• Check to ensure that all parts are pres-
ent and undamaged.
Assembling the lid handle
1. Figure B: assemble the individual
parts for the lid handle 2 as shown.
Make sure that the upper plastic
ring 12 and the lower plastic ring 13
fit into each other.
2. Carefully tighten the screw 17 with a
Phillips screwdriver. The lid handle 2
must sit securely on the lid 3 without
wobbling.
14 GB
NOTE: do not overtighten the screw 17 in
order to ensure that the glass lid 3 is not un-
der tension.
Figure C: the fully assembled lid handle 2.
Switching on for the first time
FIRE HAZARD!
Before switching on the device, place it
on a heat-resistant, flat and stable sur-
face.
The device must not be operated close
to flammable liquids or materials, or in
a potentially explosive environment.
Keep at a distance of at least 30 cm
from walls. In order to prevent overheat-
ing of the device or a potential fire, the
device must not be covered.
1. Clean the device prior to first
use!
2. Before connecting the device, make sure
that the thermostat control 9 is set to
OFF. The arrow on the temperature con-
trol light 10 must point to OFF.
3. Figure D: insert the plug with thermo-
stat 5 into the socket 6 as shown.
4. Insert the mains plug 4 into an earthed
wall socket corresponding to the specifi-
cations of the rating plate.
5. Turn the thermostat control 9 to tempera-
ture setting 5. The device heats up and
the temperature control light 10 is lit.
When the temperature setting is
reached, the light goes out.
6. Switch the device off after approx.
10 minutes by turning the thermostat
control 9 to OFF.
7. Pull out the mains plug 4.
8. Let the device cool down before mov-
ing, cleaning and storing it away.