cecotec POWER ESPRESSO TOUCH COLDBREW Bedienungsanleitung Seite 21

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Water tank cover
2. Water tank
3. Steam knob
4. Control panel
5. Cup-warming tray
6. Cup/mug tray
7. Steamer
8. Drip tray
9. Double-coffee filter
10. Portafilter
11. Portafilter handle
12. Measuring spoon with tamper
13. Single-coffee filter
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
Make sure all parts and components are included and in good conditions. If there is any piece
missing or in bad conditions, contact the official Cecotec Technical Support Service immediately.
Box content
- Espresso coffee machine
- Instruction manual
First cleaning
Warning: clean the coffee machine before using it for the first time to remove all possible
manufacturing residues.
1. Pour water into the water tank, do not exceed the "MAX" mark, and place the water tank in
its correct position.
2. Insert the portafilter and filter (empty) in their position.
3. Place a cup on the cup/mug tray. Make sure the steam knob is in the OFF position.
POWER ESPRESSO TOUCH COLDBREW
40
4. Connect the coffee machine to the mains and press the power icon. The other icons will
light up.
5. Press the 2X Espresso icon, it will flash indicating that the appliance is preheating. When
the icon stops flashing and remains steady, the appliance is ready to brew coffee.
6. Press the icon again for the machine to dispense water.
7. Once the machine has finished dispensing water, throw away the remaining water and
clean all containers thoroughly.
8. Now, the machine is ready to be used.
Warning: when activating the pump for the first time, the appliance may make some noises
which will
disappear after 20 seconds. This is because the appliance is releasing air and is completely
normal, it does not affect the operation.
3. OPERATION
Control panel. Fig. 2
1. Power icon
2. Cold Espresso icon
3. Americano icon
4. Espresso icon
5. 2X Espresso icon
6. Steam icon
7. Display
Coffee preparation
1. Make sure that the appliance is switched off and disconnected from the mains.
2. Remove the water tank by pulling from it upwards. Fill the water tank with fresh water. DO
NOT exceed the MAX. fill level line.
3. Replace the water tank and make sure it is securely in place.
4. Place the filter inside the portafilter.
5. Fill the filter with ground espresso using the measuring spoon provided. The key
to obtaining a quality espresso, in addition to the type of coffee used and the level of
grinding, is to distribute and press it evenly in the filter with the tamper. It must also be
ensured that the filter is always clean and free of coffee residues.
Note:
- If the grind is too fine, the coffee will be over-extracted, resulting in a bitter coffee, with
an irregular, spotty crema.
- If the grind is too coarse, water will quickly pass through the ground coffee without being
ENGLISH
POWER ESPRESSO TOUCH COLDBREW
41