x-sense Link+Pro XS01-M Bedienungsanleitung Seite 7

receive push notifications on your phone from the X-SenseHome
Security app.
NOTE: The XSOI -M smoke alarms can be connected
Link' Pro and Linkf alarms using wireless interconnection without
being connected to the base station.
How to Set Up and Interconnect Wireless Alarms
The wireless interlinked alarms
enab esyou to wirelessly connect 2 or more interlinked alarmsand
create an interlinked network, When one unit is triggered, al
interconnected alarms will sound.
alarms contain wireless interlinked smoke alarms wireless interlinked
carbon monoxide alarms, and wireless interlinked combination
and carbon monoxide alarms.This model is designed to be wirelessly
interlinked with other X-Sensealarms,but is not designed to
communicate with wireless interlinked
manufacturers.
The X-Sensewireless interlinked alarmsin one multi-pack have already
been interconnected, and the alarms in each mu ti-pack havetheir
own independent interlinked network. fyou have more than one
multi-pack, you will need to connect them all to the same network.
Choose one multi-pack asyour basenetwork and connect the other
multi-packs to it
to the X-Sense
contain a built-in RF module that
The X Sense wireless interconnected
alarms from other
10
NOTE:The following instructions regarding wireless interconnection
are applicable to the X-SenseLinkwPro and Link• wireless interlinked
alarms only.
How to Interconnect
1. Make sure you only work with 2 units at a time, and make sure that
they areboth turned on to ensure successfulconnection.
NOTE: Toturn on XSOI-M, pull out the battery insulating film from
the battery compartment. TOlearn how to turn on different models
of wireless interlinked alarms, please refer to their specific user
manuals
2.Quickly pressthe test/silence button on one of the 2 units 4 times; it
will beep once and the red LEDwil flash slowly,indicating it has
smoke
entered pairing mode and is waiting for a new unit to be addeci
Quickly pressthe test/silence button on the other unit twice; it wil
beep once and the red LEDwill flash rapid y, indicating it ISsearching
for a device
3.After the searchis successfuland an interconnected group is created,
both units wil beep once and automatically exit the interconnection
mode. At this point, both units will on y flash once 60 seconds,
indicating they are in normal standby mode.
f you want to connect a third alarm to this group, first activate a new
4
device by pulling out the battery insulatingfilm, then quickly press
for more details.
to connect to.
11