x-sense Link+Pro XS01-M Bedienungsanleitung Seite 8

the test/silence button on either of the 2 previously interconnected
units 4 times. This unit will beep once, and the red LEDwil tlash
slowly, indicating it is ready to add a new device to the network.
Next,quickly pressthe test/silence button on the new unit twice,
and the red LEDwill flash rapid y, as it searchesfor a network to
connect to. After the third unit successfullyjoins the interconnected
network, both units wil beep once and automatical y exit the
interconnection mode.
5. f you want to connect more units, simply repeat step 4. up to 24
alarms can be interconnected this way. To ensure that all alarms
enter the same interlinked network, make sure you only work
with 2 units at a time—one unit enters the pairing mode and the
other unit enters the searching mode.
6. Test the alarms according to the steps in the section "AlarmTest."
auicklypress
4 times
Quicklypress
12
NOTES
1. Thealarm will enter the searching mode or the pairing mode for
60 seconds with the red LED flashing. After 60 seconds, repeat step
2 to connect the alarms. If needed, press the test/silence button
once while the alarm is in the searching mode or the pairing
mode, and the red LED will stop flashing and the alarm will quit
the pairing mode to enter normal status.
2. Testall wireless alarms to ensure they are interconnected before
installation.
3. A maximum Of 24 wireless alarms
same network.
4. Themodel can only be interconnected with other X-SenseLink
Pro and Link* wireless interlinked
How to Disconnect
Quickly pressthe test/silence button 4 times; the smoke alarm will
beep once. Then, hold down the button until it beeps once more to
can be interconnected on the
alarms.
13