x-sense Link+Pro XS01-M Bedienungsanleitung Seite 9

disconnect. After disconnecting, it can be reconnected to the same
network, or added to a new network.
NOTE: The X-Sense Link• Pro wireless
mufti-pack have already been interconnected. TOcreate a new
network, you will first need to disconnect each alarrn individually
in this multi-pack to avoid having them all join the same network.
Alarm Test
Be sure to test your alarmswhen you turn them on for the first time, or
when the group configuration haschanged. n addition to the weekly
tests you should perform, it is recommended to test the alarm after
returning from a long trip or vacation.
f your X-SenseXSO I -M smoke alarm is interconnected to other
wireless alarms,we recommend that every individual alarm is tested
during the weekly test.
Test a Single Alarm
Action Press the test/silence
button. Or tap the
Device Test button
its Device Settings
page in the app.
interlinked alarms in one
Test All Interconnected
Alarms
Hold down the test/silence
button.
in
14
• The alarm wil beep 3
ndication
times every4 seconds.
• The red LED will flash
during the audible
signa .
• For devices connected
to the base station, a
push notification wi
be sent to your
smartphone.
• Then the alarm wil
automatically enter
standby mode.
• The initiating unit wil beep
continuously with the red
LEDflashing.
• Other interconnected
alarms in the network will
receive the signal after 5
seconds,then they wi
beep continuously with the
LEDflashing red and green
successivey (red on y for
XSOI-M). Re ease the
test/silence button and al
the units will stop testing.
• The testing of the units
shou d be completed
within 3 minutes.
• After testing, the units will
automatically enter
standby mode,