Progress PBD34103X Benutzerinformation Seite 16

8. Clean the glass panels with water and
soap. Dry the glass panels carefully. Do
not clean the glass panels in the
dishwasher.
9. After cleaning, install the glass panel and
the oven door.
If the door is installed correctly, you will hear
a click when closing the latches.
The screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel
frame on the screen-printing zones is not
rough when you touch it.
When installed correctly, the door trim clicks.
Make sure that you install the internal glass
panel in the seats correctly.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
In any cases not included in this table please
contact an Authorised Service Centre.
16 ENGLISH
11.6 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Back lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
A
Problem
The appliance does
not heat up.
The door gasket is
damaged.
Cause and reme‐
dy
The fuse is blown.
Make sure that the
fuse is the cause of the
malfunction. If the
problem persists, con‐
tact a qualified electri‐
cian.
Do not use the appli‐
ance. Contact an Au‐
thorised Service Cen‐
tre.