8.2 Setting: Time of Day
1.
- press repeatedly to change the time
of day.
- flashes.
2.
,
- press to set the time.
After approximately 5 sec, the flashing stops
and the display shows the time.
- flashes when you connect the appliance
to the electrical supply, when there was a
power cut or when the timer is not set.
- press to set the time.
8.3 Setting: Duration
1. Set a heating function and the
temperature.
2.
- press repeatedly.
3.
,
- press to set the: Duration.
The display shows
the set time ends. The signal sounds and the
appliance turns off.
9. USING THE ACCESSORIES
WARNING!
Refer to Safety chapters.
9.1 Inserting accessories
A small indentation at the top increases
safety and provides tilt protection. The
indentations are also anti-tip devices. The rim
around the shelf prevents cookware from
slipping off the shelf.
Wire shelf
,
- flashes.
.
- flashes when
4. Press any button to stop the signal.
5. Turn the knobs to the off position.
8.4 Setting: Minute Minder
1.
- press repeatedly.
2.
,
- press to set the time.
The function starts automatically after 5 sec.
When the set time ends, the signal sounds.
3. Press any button to stop the signal.
4. Turn the knobs to the off position.
8.5 Cancelling: Clock functions
1.
- press repeatedly until the clock
function symbol starts to flash.
2. Press and hold
The clock function turns off after few
seconds.
Insert the shelf between the guide bars of the
shelf support and make sure that the feet
point down. Make sure that the shelf touches
the back of the oven interior.
Deep pan
Push the tray between the guide bars of the
shelf support.
- flashes.
.
ENGLISH
11