Silvercrest SAS 100 A1 Bedienungsanleitung Seite 32

Turn the blade lock
the blade lock
[ 3 ]
circular blade (Fig. G).
4 ] [
After cleaning: Allow the circular blade
to dry.
Cleaning the accessories
Wipe the accessories with a slightly damp
cloth.
Use a little mild soapy water if needed.
Wipe the slicing carriage
plate , the waste holder
11 ] [
damp cloth or alternatively wash them in the
dishwasher.
Allow all parts to dry.
H
After cleaning: Reattach the circular
blade . Rotate the blade lock
[ 4 ]
clockwise direction to reattach the circular
blade (Fig. H).
[ 4 ]
clockwise and align
[ 3 ]
vertically. Remove the
4 ] [
, the slicing
10 ] [
with a slightly
12 ] [
3 ] [
[ 4 ]
in a anti-
3 ] [
˜ Full cleaning
m CAUTION! Risk of injury! The circular
blade is very sharp. Do not move the
[ 4 ]
positioning plate
13 ] [
blade during assembly, disassembly or
4 ] [
cleaning.
NOTE: The product should be fully cleaned
in regular intervals.
Clean the product and its accessories
(see "Cleaning (after each use)").
Turn the turning handle
anticlockwise direction past the 0 position.
Remove the positioning plate
the instructions in the addendum sheet.
Wipe the positioning plate
damp cloth.
After cleaning: Allow the positioning plate
to dry.
Turn the turning handle
0 position.
Reattach the positioning plate
it in the middle. Turn the turning handle
back to the 0 position.
To check that it is positioned correctly, adjust
the cutting width (see "Setting the cutting
width").
If this does not work, remove the positioning
plate again and repeat the process.
13 ] [
near to the circular
in an
1 ] [
according to
13 ] [
with a slightly
13 ] [
[ 13 ]
past the
1 ] [
by pressing
13 ] [
[ 1 ]
GB/IE 29