Parkside Performance PRDSP 20-Li C2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 30
Akku‑rucksack‑drucksprüher 20 v
Vorschau ausblenden
Andere Handbücher für PRDSP 20-Li C2:
- Bedienungs- und sicherheitshinweise originalbetriebsanleitung (357 Seiten) ,
- Bedienungs- und sicherheitshinweise (193 Seiten) ,
- Bedienungs- und sicherheitshinweise originalbetriebsanleitung (325 Seiten)
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Secure the product against slipping and
o
tipping .
˜ Troubleshooting
m
WARNING! Risk of accidental contact of spray materials with skin and eye!
u
Always wear appropriate personal protection equipment as instructed by the chemical
manufacturer when using, preparing, handling, spraying, or disposing of chemicals . This
equipment includes at least goggles, gloves, respiratory protection and protective clothing .
u
Before starting to work with the product, squeeze down the trigger
been released completely . If the pressure has not been released beforehand, chemicals may
splash out in an uncontrolled manner when working with the product .
u
After work, carry out a test run with clean water .
Fault
The product cannot be
switched on .
The product does not spray .
A leakage occurs .
28 GB
Possible cause
[
18 ]
The battery pack
is not
inserted properly .
[
18 ]
The battery pack
is empty .
No pressure present .
No chemicals in the spray
3 ]
[
tank
.
[
12 ]
Nozzle accessories
[
33 ]
cone spray head
are
blocked .
[
36 ]
The small filter
is blocked .
Related parts are not properly
connected .
The sealant ring is damaged .
28 ]
[
until the pressure has
Solution
Insert the battery pack
properly .
Charge the battery pack
Switch off the product: Press
the power button
Fill the spray tank
chemicals .
Switch off the product, remove
the battery pack
release the pressure .
or
Clean the nozzle
12 ]
[
accessories
[
33 ]
spray head
a needle through them
(see "Cleaning and care") .
Switch off the product, remove
the battery pack
release the pressure .
Clean the small filter
running water using a brush
(see "Cleaning and care") .
Switch off the product, remove
the battery pack
release the pressure .
Connect the related parts
properly .
Switch off the product, remove
the battery pack
release the pressure .
Replace the sealant ring .
[
18 ]
[
18 ]
.
14 ]
[
.
3 ]
[
with
[
18 ]
and
or the cone
by pushing
[
18 ]
and
36 ]
[
under
18 ]
[
and
18 ]
[
and
Werbung
