To Clean The Paddle Wheel; Storage; Waste Disposal And Environmental Protection; Spare Parts Order - FLORABEST FTP 400 B2 Betriebsanleitung

2. Insert the seal (10b) into the back
flow stop (10a).
3. Set the backflow stop (10) be-
tween the angle adapter (11) and
the adapter with the hose con-
nection (9) in such a manner that
the stop is opened in the flowing
direction and closed against the
flowing direction.

To clean the paddle wheel

In the case of too severe precipitation in the
pump casing (3), the lower part of the pumps
must be disassembled as follows:
1. Loosen the 3 screws on the under-
side of the base (4) and take off
the base.
2. Clean the paddle wheel with clear
water.
Caution! Do not place or support
the pump on the paddle wheel!
3. Insert the sealing ring (13) into the
base (4).
4. Position the base (4) on the pump
casing (3) such that the notch (14)
on the base (4) is at the level of the
pump output (5).
Any measures above and beyond these,
particularly opening the equipment, are to be
carried out by an electrician. In the case of
repairs, always contact our service centre.

Storage

• Clean the pump before storage.
• Store the appliance in a dry, frost-free
place, and where children cannot gain
access to it.
• When the pump is not to be used for
a longer period, it must be thoroughly
cleaned after its last use, and before it
is next used. Otherwise there may be
problems in starting the pump, caused by
deposits and residues.
Waste Disposal
and Environmental
Protection
Be environmentally friendly. Return the tool,
accessories and packaging to a recycling
centre when you have finished with them.
Electric appliances should not be dis-
posed of in the domestic garbage.
Hand the tool in at a recycling centre. The
plastics and metal parts can be separated
and recycled. Ask your Service Center about
this. Defective units returned to us will be dis-
posed of for free.

Spare Parts Order

When buying parts for the submersible water
pump, use the service address given.
Please enter your machine type and the item
number of the part you are ordering or its
position on the exploded drawing.
Backflow stop ............. item No. 91101243
The backflow stop is subject to wear; its re-
placement is not covered by guarantee.

Guarantee

Dear Customer,
This equipment is provided with a 3-year
guarantee from the date of purchase.
In case of defects, you have statutory rights
against the seller of the product. These
statutory rights are not restricted by our
guarantee presented below.
GB IE CY
11