Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.6 DIT-IR connection
Place the DIT-IR as close as possible to the photometer.
Fig. 5
DIT-IR connection
4. Installation of the device driver and data
acquisition software
4.1 Driver installation
Installation as described in this manual is based on a
Windows XP platform. If you use another Windows
Note
operation system, please proceed analogously.
After the DIT-IR is connected to the USB interface for the first
time, an installation assistant opens automatically. Make the
selection shown below and click [Next].
Find the driver under "[CD drive name]:\inf" on the CD supplied.
After inserting the CD and setting the following selection, start
searching the CD by clicking [Next]:
6
When the driver has been found, the message shown below
appears. Confirm the installation by clicking [Continue Anyway].
The driver will be installed.
Complete the installation to close the installation assistant.
Restart the PC.
A virtual COM port has been created. The address of the port can
be seen in the device manager. It can be opened from the
desktop as follows:
Werbung
