Installation Preparations; Installation - Maico EVN 22 Montageanleitung Und Bedienungsanleitung

7. Installation preparations, fig. A
Danger of injury due to cuts
caused by glass breakage, if
the windowpane is under stress.
DANGER
Only install the windowpane so
that the glass is not under stress.
If necessary, remove the window-
pane and re-fit it so that it is not
under stress.
1. Get an expert to make the window cut-out
[S]. Drill the cut-out [S] in the case of wall /
wooden panel installation.
Make sure there is sufficient space to
the window frame, wall or ceiling.
2. Lay power cable [L].
3. Clean the windowpane thoroughly before
adhesively bonding the shutter on.
8. Installation, fig. B ... H
Danger of short-circuits, unit
NOTICE
damage Water will penetrate if
the power cable is incorrectly
fed into the housing or if the
cable grommet is not fitted
correctly.
The degree of protection is only
guaranteed if the cables are fed
through correctly at the cable
grommet [T1] or [T2]. Pierce the
cable grommet, so that the
power cable can tightly seal it.
Notes
● Never dismantle the shutter.
● Only install shutter [1] in combination with
the connecting flange [2].
Fig. B: Disassembling the inner parts
1. To do this, hold the internal housing [3]
firmly at the side and pull the connecting
flange [2] at the motor out of the cover.
2. Remove the terminal box cover [4].
7. Installation preparations │ gb
In case of wall / wooden panel installation:
3. If necessary, drill through the connecting
flange [2] on the 2 knockout points [Y]
( Fig. B).
4. Drill through the 4 knockout points [Z]
( Fig. B1) on the shutter, with the
lamellae open.
Fig. C/Fig. C1: Installing the shutter
[1] (outside).
1. Insert the 4 screws [6] into the eyes of the
shutter until they snap into place.
2. Remove the protective foil from the gluing
points [5].
3. EVN 22 R: Guide the connecting cable [7]
through the window cut-out.
4. Align the shutter in the window cut-out and
press it onto the pane.
In case of wall / wooden panel installation:
5. Attach the shutter [1] to the wall or wooden
panel with suitable mounting material
supplied on-site.
Fig. D and E: Installing the inner parts
(inside)
Danger of injury due to cuts
caused by glass breakage, if the
nuts have been over-tightened.
CAUTION
Tighten the lock nuts [8] carefully
making sure not to over-tighten
them.
1. EVN 22 R: Guide the connecting cable [7]
into the connecting flange.
Shutter does not close
NOTICE
properly, if it is tensely
installed.
Only mount the shutter on a
level surface in order to
guarantee the shutter function.
2. Attach the connecting flange [2] to the
screws [6], align it and press it gently
against the windowpane.
3. Tighten the locking nuts [8] with the
supplied socket spanner [9].
13