Spare Parts; Dismantling; Disposal - Maico EVN 22 Montageanleitung Und Bedienungsanleitung

gb │ 11. Fault, rectification
Fault Cause, measure
Fan does not No mains voltage.
Check whether the mains
switch on.
fuse has failed. Switch on if
necessary.
Motor's thermal
Motor too hot.
Leave the unit switched off
overload
until the motor and the
protection
temperature limiter cool
switches the fan
down. Cool-down time can
off.
be up to 30 minutes. Only
then, switch the unit back
on.
Impeller is blocked.
Fan does not
Check impeller and clean if
switch on.
necessary.
If the fault still continues or occurs
again, disconnect the fan from the
power supply at all poles. Let a
certified electrician determine the
cause of the fault and eliminate it.

12. Spare parts

Spare parts may only be sourced from
and fitted by a specialist installer.
Item Designation
1 Shutter, complete 22
1 Shutter, complete 22 R
2 Connecting
flange, complete
2.1 Motor with screws 22
2.1 Motor with screws 22 R
2.2 Impeller with
clamping ring
2.3 Servomotor
(actuator)
3 Internal housing,
complete
3 Internal housing,
complete
13 Pull-switch,
complete
16
Type Article no.
0059.0178.9001
22 P
0059.0178.9101
22 0059.0181.9000
22 P
22 R
0156.0094.0001
22 P
0156.0095.0000
22 0061.0220.0000
22 P
22 R
22 R 0157.0972.9000
22 0059.0182.9000
22 P
22 P E059.0182.9100
22 P 0157.1069.0000
In case of questions:
Maico Elektroapparate-Fabrik GmbH
Steinbeisstraße 20
78056 Villingen-Schwenningen
Germany
Tel. +49 (0)7720 694445
Fax +49 (0)7720 694175
E-Mail: ersatzteileservice@maico.de

13. Dismantling

Dismantling may only be undertaken
by a trained electrician ( Chapter 1).
Danger to life from electric
shock.
DANGER
Prior to access to the connection
terminals switch off all supply
circuits. Switch off mains fuse,
secure against being accidentally
switched back on and position a
visible warning sign.

14. Disposal

Do not dispose of in domestic
waste.
The unit contains in part materials
that can be recycled and in part
substances that should not end up
in the domestic waste.
Dispose of the unit once it has reached the
end of its service life according to the
regulations valid where you are.