Non-Permitted Operation; Safe And Correct Practices During Operation; Installation Preparations; Installation - Maico EC 30 E Montage- Und Betriebsanleitung

GB
Operations only permitted when fitted at a
sufficient space from the wall, other ceiling
fans or equipment in the vicinity.
EC 90 B, EC 140 B: Operation only
permitted with a minimum gap of 2.3 m
between floor and bottom edge of impeller
blades.

5.3 Non-permitted operation

The fan unit should not be used:
close to flammable materials, liquids or
gasses.
for the conveying of chemicals, aggressive
gases or vapours.
in explosive atmospheres.
5.4 Safe and correct practices during
operation
Danger of injury. Do not place anything in
the rotating impeller blades.
Danger from rotating impeller blades.
Do not get too close to the unit, to avoid
hair, clothing or jewellery being drawn into
the unit.
The unit is not intended to be used by
people whose physical, sensory or mental
capabilities are not sufficient for them to
understand and put into practice the safety
information provided in these instructions.
This limitation also applies to children.
The unit may however be safely used by
such persons if they are supervised by
someone responsible for their safety or if
they are instructed in a suitable way.
14

6. Installation preparations

Observe permissible minimum installation
height. For EC 90 B and EC 140 B
min. 2.3 m (bottom edge of impeller blades
to floor, according to EN 60335-2-80).
The following fastenings must be provided
on site:
– 1 ceiling hook with 7 mm diameter,
strength class 4.8
– 1 suitable retaining dowel
Make a hole for the retaining dowel in the
ceiling.
Insert retaining dowel.
Screw in ceiling hook.

7. Installation

7.1 EC 30 E and EC 40 D installation

These ceiling fans come from the factory
ready for installation. For conversion to a
longer fastening rod (accessories), see
section 8.
Incorrect installation results in
a danger of injury from falling
unit parts.
DANGER
When installing and also after
dismantling, always use new
lock nuts according to ISO
7042.
Malfunction if the ceiling fan
cannot swing freely.
Leave 5 to 8 mm gap between
CAUTION
upper edge of canopy [4] and
ceiling.
Lift up ceiling fan and hang rubber roller [2]
of fastening rod in ceiling hook [1].
Undertake electrical connection according
to section 7.3.
Slide canopy [4] towards ceiling and lock
with setting ring [5].