Werbung
Product Operation
Water tank operation
The water tank, including the mop cloth, is already pre-installed when unpacking. Please
fill the water tank with water before mopping. It is recommended to vacuum the floor
before mopping. For daily care, please read the tips in the corresponding chapter in this
manual.
Note
1. Please do not allow the robot to mop on carpets or rugs.
2. To refill the water tank, you must remove it from the robot. Make sure that
you refill the water tank and clean the mop and the mopping plate in good
time, even during the mopping process if they are very dirty.
3. Make sure that you remove the mopping plate with the wet mop after
mopping before the robot is charged at the charging station.
18
English EN
Find more information at www.zaco.eu
EN English
Product Operation
1 Remove the water tank
•
Press the release button for the water tank and pull the tank backwards to remove it.
2 Add water
•
Open the lid of the water tank and fill the tank with water. Close the lid tightly again
after filling with water.
3 Place the mop cloth
•
Attach a mop to the mopping plate before you attach it to the water tank.
4 lnstall water tank
•
After you have connected the mopping plate and the water tank, push them back
into the robot. When you hear a "click" sound, it is firmly installed. You can press the
mopping button to automatically execute the corresponding mopping mode.
Find more information at www.zaco.eu
19
Werbung
