SICK microScan3 - PROFINET M12 Montageanleitung Seite 17

8.1 Replacing the safety laser scanner without system plug
8.2 Replacing the safety laser scanner completely
9 Replacing the system plug
8020210/1NTN/2024-05-07 | SICK
Subject to change without notice
1. Make sure that the environment is clean and clear of fog, moisture, and dust.
2. Unscrew screws in the system plug and remove the system plug from the defective
safety laser scanner.
3. Unscrew the fixing screws and remove the defective safety laser scanner.
4. Mount the system plug on the new safety laser scanner, see
system plug".
5. Mount the new safety laser scanner, see
directly".
6. Perform commissioning again, taking particular care to conduct all of the thorough
checks described. For more information, see the operating instructions.
1. Disconnect the connecting cables the system plug.
2. Unscrew the fixing screws and remove the defective safety laser scanner.
3. Mount the new safety laser scanner, see
directly".
4. Reconnect the connecting cables to the system plug.
5. Configure the safety laser scanner.
6. Perform commissioning again, taking particular care to conduct all of the thorough
checks described. For more information, see the operating instructions.
M O U N T I N G I N S T R U C T I O N S | microScan3 – EFI-pro, microScan3 – EtherCAT®, microScan3 – PROFINET (M12),
MOUNTING INSTRUCTIONS
"Replacing the
"Mounting the safety laser scanner
"Mounting the safety laser scanner
microScan3 – EtherNet/IP™
en
17