System Lay-Out; Technical Features; Technical Data - RIB K1800 Gebrauchsanweisungen Und Installation

SYSTEM LAY-OUT

Fig. 1
1 - CHECKING BEFORE THE INSTALLATION
!! THE GATE SHALL MOVE FRICTIONLESS !!
N.B.: Gate features must be uniformed with the standards and laws in
force.
The guide must be provided with two mechanical stops at its ends (12)
(Fig. 2).
Gate columns shall have anti-derailment guides on their top (Fig. 3), to
avoid the unintentional gate release.
N.B.: Eliminate those mechanical stops of the kind described by figure 3.
No mechanical stop shall be on top of the gate, since mechanical stops
are not safe enough.
Fig. 2
Fig. 3
RELEASE
To operated after the power supply to the motor has been interrupted.
In order to work manually on the gate, you just need to insert the fitting key and rotate It
3 times counterclockwise (Fig. 4).
Fig. 4
Parts to install meeting the EN 12453 standard
COMMAND TYPE
with manned operation
with visible impulses (e.g. sensor)
with not visible impulses
(e.g. remote control device)
automatic
* a typical example are those shutters which do not have access to any public way
A: Command button with manned operation (that is, operating as long as activated), like code ACG2020
B: Key selector with manned operation, like code ACG1010
C: Safety edges, like code ACG3010
D: Photocells, like code ACG8026
Irreversible operating devices for sliding gates with a maximum weight of 2.200
Kg/4900lbs.
The irreversibility of this operating device allows you to avoid using any electric lock for
an effective closing of the gate. The motor is protected by an heat probe, that temporary
interrupts the operating cycle in case of prolonged use.
TECHNICAL
DATA
Max. leaf weight
Operating speed
Thrust force to constant turns
Rack
EEC Power supply
Motor capacity
Power absorbed
Capacitor
No. cycles
Grease
Weight of electroreducer
Noise
Working temperature
Protection
1 - K operating device
2 - External photocells
3 - Rack of Module 4
4 - Key selector
5 - Radio antenna
6 - Blinker
7 - Travel limiting devices (cams)
8 - Mechanical strip
9 - Pneumatic strip or Fotocosta
10 - Internal Photocells
11 - Photocell posts
12 - Mechanical stops
USE OF THE SHUTTER
Skilled persons Skilled persons Unrestricted use
(out of a public area*) (public area)
A B
C C
C C e D
C e D C e D

TECHNICAL FEATURES

K1800
Kg/lbs 1800/3960
0,166m/sec - 32,6 ft/min
640N-144lbs
4
230V~ 50-60Hz
W 257
A 1,18
µF
12,5
n° 9 - 60s/2s
AGIP GR SLL 00
10,5Kg/23lbs
db <70
°C -10 ÷ +70°C
IP 54
Pag. 15 di 28
E
N
G
L
I
S
H
C e D
C e D
C e D