Changing The Bitrate Of The Service Port - G&D Dvimux4-Usb Installation Und Bedienung

Changing the bitrate of the Service port

The Service port of the KVM switch can be used both for operating the setup menu
and for switching the channels with a serial device.
The Service port transfers a certain amount of data per time unit. The bitrate is given
in bit/s.
IMPORTANT:
Transmitter and receiver of the data must use the same bitrate to
ensure successful communication between the terminal emulator or a serial device
and the KVM switch.
If the bitrate cannot be adjusted to the standard bitrate of the KVM switch (115.200
bit/s) in the terminal emulator or the serial device, the bitrate of the Service port can
be modified.
How to select the bitrate of the Service port of the KVM switch:
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Switch mode of the service port is
enabled. Enter »
2. Use the
Arrow
3. Press the Space
115200  serial data transmission with 115.200 bit/s
 serial data transmission with 9.600 bit/s
9600
4. Press the S key to save your settings.
#! « to switch to the setup menu.
or keys to select the
Arrow
key (repeatedly) to choose between the following bitrates:
Configuration
entry.
Service RS232 Bitrate
G&D DVIMUX4-USB · 27